2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 354Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 354

8In crisscrosscase-to-case pattern, tighten the mm cap screws (from steps 5-6) to 0.9-1.3 kg-m (6.5-9.5 ft-Ib) NOTE: Rotate
StrainerOil Pump BGear Shift Shaft 1Place the oil strainer with new O-ring into position beneath the crankcase and tighten
securely with the Phillips-head cap screws 6From the right side, install the five case half mm cap screws (one inside the
case); then tighten only until snug NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 2Place
the strainer cap into position on the strainer making sure the O-ring is properly installed and secure with the cap screws;
then install and tighten the oil drain plug to 2.2 kg-m (16 ft-Ib) 7In crisscrosscase-to-case pattern, tighten the mm cap