2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 356Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 356

CPrimary Driven Gear DPrimary Clutch EStarter Clutch Shoe NOTE: Steps 1-7 in the preceding sub-section must precede this
the hub and plate will have clearance between them and they will not operate properly 11Simultaneously, place the primary
clutch assembly and the starter clutch housing on their respective shafts making sure the sleeve is properly positioned in
the primary assemblyCC081D 9Place the chain into the crankcase; then secure it from the top side with wire for ease of assembling
NOTE: Note the alignment mark scribed on the primary driven gear assembly during disassembly 12Using the Clutch Sleeve Hub