2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 363Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 363

23In crisscross pattern, tighten the cap screws to 0.9-1.3 kg-m (6.5-9.5 ft-lb)24Place the shift stop housing assembly into
the shift lever assembly the rest of the way onto the shift shaftSecure with the outer circlip making sure the sharp side
of the circlip faces away from the hilow-range lever CAUTION Make sure the speedometer gear and output shaft gear match up
during assembly 28Place the starter cup into position on the crankshaft making sure new, lubricated O-ring is inside the
cupTighten the flange nut to 3.5 kg-m (25 ft-lb) 26Install the inside circlip onto the hilow range shift shaft with the sharp
side of the circlip facing the engine; then place the shift lever assembly part way onto the shaft 29Place the recoil starter