2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 373Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 373

13Place the speedometer cable into position and tighten the knurled nut 15Place the footrests into position on the frameTighten
the existing hardware and tighten securely21Carefully gUide the battery cables and fuse block wiring up through the access
hole into the battery tray22Connect all fuse block wiring according to the marking made in removing; then place the fuse
block into position and secure with two screws NOTE: If the mounting screw holes have elongated, it will be necessary to
install larger diameter screws 14To install the reverse shift rod, use the following procedure: APlace the reverse shift
arm onto the engine reverse shift shaft (with the marks made during disassembly aligned) and secure with the cap screw &
CAUTION It is critical that all wiring be installed correctly to ensure electrical components will function properly BSecure