2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 393Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 393

4Install the lower coolant hose onto the water pump housing and radiatorSecure with the two hose clamps5Fill the cooling
procedure ATap the tip of small sheet metal screw into the inner-metal edge of the seal INSTALLING 1Position the fan assembly
on the radiator; then secure with existing hardware NOTE: The fan wiring must be in the upper-right position 2Install the
radiator (see Radiator in this section) BGrip the screw with pair of vise-grip pliers and pull the seal outAccount for the
pump drive sealCLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement
is necessary 1Clean all pump components in solvent2Inspect the mechanical seal and pump drive seal for damage NOTE: If the
mechanical seal andor pump drive seal are damaged, they must be replaced as set 3Inspect the impeller for corrosion or damageE