2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 394Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 394

ASSEMBLINGINSTALLING NOTE: Treat seals and O-rings with clean antifreeze for initial lubrication 3Place the water pump case
seal with pump drive seal into the impeller by hand2Install the mechanical seal assembly onto the water pump shaft and secure
with the cap screw, washer, and gasketTighten the cap screw securely 5Check the entire cooling system for leakage Servicing
Water Pump (500Automatic Transmission) NOTE: When servicing the water pump, it will be necessary to install new Oil Seal
(pIn 3402-465) and new Mechanical Seal (pIn 3005-909) 123456789101112Water Pump Assy Cap Screw (Drain) Gasket a-Ring Impellershaft