2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 396Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 396

CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
housing; then using seal driver, gently tap the seal down until it is fully seated CAUTION Failure to properly engage the
two shafts could cause serious engine damage 5With the bearing housing assembly in position on the engine, place the cover
(with O-ring installed) into position on the housing; then loosely secure with the two Phillips-head cap screwsINSTALLING
1Secure the water pump to the engine with the two cap screws tightened securely; then tighten the two Phillips-head cap screws
securely 2Place the new mechanical seal into the bearing housing; then tap it down until it is fully seated NOTE: large deep-well