2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 401Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 401

Limiter Screw ATV-0053 3The meter must show battery voltage Testing Electrical Components All of the electrical tests should
fuse, receptacle, connector, or the main wiring harness Brakelight Svvitch (Auxiliary) The switch connector is the two-prong
connector on the right side of the engine directly above the brake cable adjuster NOTE: The ignition switch must be in the
ON position VOLTAGE (Wiring Harness Side) 1Set the meter selector to the DCVoltage position Accessory ReceptacleConnector
2Connect the red tester to the orange wire; then connect the black tester lead to ground NOTE: This test procedure is for
either the receptacle or the connectorVOLTAGE 1Set the meter selector to the DCVoltage position2Connect the red tester lead
to the redwhite wire or the positive connector; then connect the black tester lead to groundAR627D 3The meter must show battery