2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 402Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 402

NOTE: If the meter shows battery voltage, the main wiring harness is good; proceed to test the switchcomponent, the connector,
be in the OFF position 3When the brake pedal is depressed, the meter must show less than ohm NOTE: If the meter shows more
than ohm of resistance, troubleshoot or replace the switchcomponent, the connector, or the switch wiring harness 1Set the
meter selector to the OHMS position2Connect the red tester lead to one black wire; then connect the black tester lead to
the other black WIre Brakelight Svvitch (Handlebar Control) The switch connector is the two-prong black connector in front
of the steering postTo access the connector, the front rack and front fenders must be removed (see Section 8) NOTE: The ignition
switch must be in the ON positionVOLTAGE (Wiring Harness Connector) 1Set the meter selector to the DCVoltage position2Connect
the red tester lead to the orange wire; then connect the black tester lead to ground 3When the lever is compressed, the meter