2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 405Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 405

3The meter must show 31 20 Fuses 4With the tester leads connected, depress the starter button5The meter must show l30V 20
connect the black tester lead to ground 3The meter must show less than ohm resistanceIf the meter reads open, replace the
fuse NOTE: Make sure the fuses are returned to their proper position according to amperageRefer to the fuse block cover for
fuse placement Ignition Coil On the 250300, the ignition coil is attached to the upper frame behind the right-hand side panelTo
access the coil, the seat and right-hand side panel must be removed (see Section 8)On the 400500, the ignition coil is on
top of the engineTo access the coil, the seat and gas tank (see Section 4) must be removedVOLTAGE (Primary Side) NOTE: The
ignition switch must be in the ON position; the emergency stop switch must be in the RUN positionAlso, the whiteblue wire
must be disconnected from the coil 2The meter reading must be within specificationSecondary Winding 1Set the meter selector