2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 407Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 407

1Set the meter selector to the DCVoltage position2Connect the red tester lead to the primary coil terminal; then connect
light should illuminateHI BEAM LIGHT 1Connect the jumper positive wire to the high beam terminal on the indicator light connector2Connect
the jumper ground wire to the female terminal on the indicator light connector3The HI beam indicator light should illuminateINDICATOR
LIGHTS Male Terminal Female Terminal NOTE: If light fails to illuminate in anyone of the indicator light tests, the connector,
wiring harness, or bulb must be replaced To access the indicator light connector for testing purposes, use the following
procedure1Remove the three machine screws and key cover securing the instrument pod2Remove the light bar from the instrument
pod; then cut the cable tie securing the instrument pod wiring to the steering post3Push the instrument pod wiring with light
bar to access the indicator light connector; then dIsconnect the connector from the main wiring harness NOTE: For these tests,