2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 409Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 409

10With the switch in the OFF position, connect the red tester lead to the red wire and the black tester lead to each of the
connector, or switch harnessRESISTANCE (Emergency Stop) 1Set the meter selector to the OHMS position2Connect the red tester
lead to the orange wire; then the black tester lead to the orangewhite CAUTION 3With the switch in the OFF position, the
meter must show an open circuit4With the switch in the RUN position, the meter must show less than ohm NOTE: If the meter
shows more than ohm of resistance, troubleshoot or replace the switchcomponent, the connector, or the switch wiring harnessRESISTANCE
(Reverse Override) Always disconnect the battery when performing resistance tests to avoid damaging the multi meterRESISTANCE
(HI Beam) 1Set the meter selector to the OHMS position2Connect the red tester lead to the yellow wire; then connect the black
tester lead to the gray wire3With the dimmer switch in the HI position, the meter must show less than ohm NOTE: If the meter