2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 416Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 416

7Apply small amount of grease to the front cover bearing and seal; then install the seal protector 10Apply small amount of
and the shift lever (on automatic transmission models) in the NEUTRAL position 1Set the meter selector to the DCVoltage position2Connect
the red tester lead to the starter terminal; then connect the black tester lead to ground3With the starter button depressed,
the meter must show battery voltage and the starter motor should operateBC004 8Place the front cover onto the starter housing
making sure it seats properly9Apply red Loctite #271 to the threads of the two long cap screws and installTighten to 0.8-1.2