2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 420Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 420

Neutral Start Relay The connector is the white 4-prong one near the batteryVOLTAGE (Connector) 2Connect the power supply
red tester lead to one brass terminal; then connect the black tester lead to the other brass terminal5The meter must show
less than ohm NOTE: If the meter shows more than ohm (even though the "click" was heard in the power supply test), the relay
must be replacedRESISTANCE (RelayCopper Terminals) 4With the black tester lead still connected to ground, connect the red
tester lead to the yellowgreen wire5Depress the starter buttonThe meter must show battery voltage NOTE: If the meter shows
no battery voltage, inspect fuses, wiring harness, connectors, and switchesRESISTANCE (RelayBrass Terminals) '&'CAUTION Always
disconnect the battery when performing resistance tests to avoid damaging the multi meter NOTE: An external 12-volt power
supply "jumper" (positive and negative connections) must be used for this testAlso, it is very important that the meter leads
and power supply connections are made to the appropriate terminals of the relay or damage to the multimeter will result Always