2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 438Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 438

5Install the input shaft into the housing; then install the input shaft flange 7Apply red Loctite #271 to the threads of
to secure the input shaft housing while tightening the nut, make sure to protect the input shaft housing with rag or suitable
substitute Disassembling Pinion Gear NOTE: This procedure can be performed on rear FIS gear case; however, some components
may vary from model to modelThe technician should use discretion and sound judgment 1Using T-40 torx wrench, remove the cap