2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 444Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 444

Removing Needle Bearing NOTE: Removing the needle bearing is rarely necessaryAvoid removing the needle bearing unless the
surface of the needle bearing (against the bottom side); then drill through the pinion shaft needle bearing housingInstalling
Needle Bearing 1Place the new bearing into the housing 2Using propane torch, heat the area surrounding the needle bearing
to approximately 300CC888 2Using suitable driver, install the needle bearing into the housing making sure the bearing is