2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 448Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 448

NOTE: Do not allow the brake calipers to hang from their cablehose REMOVING FRONT DRIVE AXLE (4x4 Models) may occur CAUTION
remove the hex nut and washerRelease the brake lever lock NOTE: Never reuse lock nutOnce lock nut has been removed, it must
be replaced with new lock nut 8While holding the drive axle stationary, pull the top of the knuckle out and down until it
is free of the drive axle9Place drain pan under the ATV to contain any oil leakage; then using slide hammer, remove the drive
axle NOTE: It is not necessary to remove the brake hose from the caliper for this procedure 5Remove the brake caliper NOTE: