2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 449Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 449

6Slide the hub wlbrake disc out of the steering knuckle and set aside7Remove the tie rod from the steering knuckle 2Inspect
the ball joint from the knuckle10While holding the drive axle stationary, pull the top of the steering knuckle out and down
until it is free of the drive axle11Place drain pan under the ATV to contain any oil leakage; then using slide hammer, remove
the drive axleCD020 2Wipe away excess grease to access the retaining ringUsing an awl or circlip pliers, remove the circlip
CLEANING AND INSPECTING NOTE: Always clean and inspect the drive axle components to determine if any service or replacement