2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 450Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 450

7Using side-cutters (or suitable substitute), remove both outer boot clamps from the shaftNote the position of the different-sized
positioned correctly when the small end of the boot seats down into the recessed groove 10Using Boot Clamp Pliers (pin 0444-120),
secure both outer boot clamps 5Inspect the splines of the shaft, the bearing ring, and the housing for damage NOTE: If any
damage is apparent to the splines, the bearing ring, andor the housing, the drive axle must be replaced as an assembly CAUTION
It is important that the clamps are positioned correctly or they may loosen when in motion 6Using side-cutters (or suitable
substitute), remove the small clamp from the shaft ASSEMBLING AXLES ATV-1048 1Install the inner boot with the small clamp