2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 451Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 451

2Using the boot clamp pliers, secure the small clamp of the inner boot 5Secure the bearing ring with the circlip making sure
slide the housing over the bearing ring; then install the circlip 7Slide the boot over the housing; then using the boot clamp
pliers, secure the boot with the clamp4Install the bearing onto the shaft making sure the recess of the bearing is facing
the housing 8Inspect the axle components for correct positioning of the four clampsAlso, inspect the boots for being correctly
positioned on the shaftINSTALLING REAR DRIVE AXLE (Fully Independent Suspension) CAUTION The bearing ring must go onto the