2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 452Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 452

NOTE: To assure proper seating of the axle, give it light pull; the axle should remain "clipped" in place 2Swing the knuckle
new lock nutTighten to 4.8 kg-m (35 ft-Ib)3Secure the tie rod to the steering knuckle with new lock nutTighten securely;
then install and spread new cotter pin4Slide the hub wlbrake disc into position in the steering knuckle followed by washer
and hex nutTighten finger-tight at this time5Install the brake caliper on the steering knuckleTighten to 2.8 kg-m (20 ft-Ib);
then pump up the hand brake lever and engage the brake lever lock6Tighten the hub hex nut (from step 4) to 10.4 kg-m (75
ft-Ib); then install and spread new cotter pin making sure each side of the pin is flush to the hub nut 7Install the wheel
and tighten to 5.5 kg-m (40 ft-Ib)8Remove the ATV from the support stand and release the brake lever lockCD027 7Install the
wheelTighten to 5.5 kg-m (40 ft-Ib)8Remove the ATV from the support stand and release the brake lever lock9Check the enginetransmission