2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 455Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 455

NOTE: If new gear housing is being installed,tighten the cap screws to 5.1-6.3 kg-m (37-45.5 ft-Ib) CC771 CLEANING AND INSPECTING
the bearingsASSEMBLING 1Grease the splines of the ring gear 3Secure the axle housing to the rear gear case with four 37 mm
(1.5 in cap screwsTighten to 4.3-5.3 kg-m (31-38 ft-Ib) NOTE: If new gear housing is being installed, tighten the cap screws
to 5.1-6.3 kg-m (37-45.5 ft-Ib) 4Lightly grease the bearing housing seal; then slide the bearing housing onto the axle shaftSecure
with the snap ring 2Make sure the rear gear caseaxle housing O-ring is properly positioned; then secure the axle housing