2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 467Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 467

3Secure the two right side swing arms to the frame brackets with cap screws and hex nutsDo not tighten at this time4On the
free from the swing arm 8Lower the floor jack and remove the swmg armrear drive assembly9Remove the four cap screws and lock
nuts securing the swing arm to the axle housing; then remove the swing armCLEANING AND INSPECTING NOTE: Whenever part is
worn excessively, cracked, or damaged in any way, replacement is necessaryCC783 NOTE: Note the routing of the brake hose
for installing purposes 1Clean all swing arm components in parts-cleaning solvent2Inspect all swing arm weldments for cracks
or unusual bends3Inspect all tubing for cracks or unusual bendsINSTALLING CAUTION Care should be taken not to damage or kink
the brake cablehose 5Remove the three cap screws securing the rear gear case V-joint to the drive shaft6Remove the cap screw
and lock nut securing the shock assembly to the swing armDiscard the lock nut7-6 1Place the swing arm into posItIOn on the