2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 468Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 468

NOTE: Ensure that the brake hose is properly routed and secured on the swing arm as noted during removing 2Place the axle
remove the wheelCC864 4Secure the shock absorber to the swing arm with cap screw and new lock nutTighten to 4.8 kg-m (35
ft-lb) Make sure the ATV is solidly supported on the support stand to avoid injury 2Remove the wheel cap from the hub; then
remove the cotter pin from the nut 5Secure the rear gear case V-joint to the driveshaft with three cap screws coated with
red Loctite #271Tighten to 5.5 kg-m (40 ft-lb)6Secure the brake calipers to the bearing housing with existing hardwareTighten