2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 473Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 473

INSTALLING 1Install the A-arm assemblies into the frame NOTE: Ensure that the brake hose and brake cable are properly routed
the pin to secure the nut 5Insert the hub seal onto the shaft; then position it into the hub 10Secure the shock absorber
to the frame with cap screw and new lock nutTighten to 4.8 kg-m (35 ft-Ib )11Secure the shock absorber to the lower -arm
with cap screw and new lock nutTighten to 2.8 kg-m (20 ft-Ib)12Secure the boot guard to the lower A-arm with the two cap
screwsTighten securely6Place the washer onto the drive axle; then secure the hub assembly with the nutTighten only until
snug7Secure the brake caliper to the knuckle with the two cap screws (right side only)Tighten the mechanical caliper to 2.1
kg-m (15 ft-Ib)Tighten the hydraulic caliper to 2.8 kg-m (20 ft-Ib)13Install the wheel cap14Install the wheel and tighten