2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 475Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 475

CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
level surface and note any pulling to the left or right during acceleration, deceleration, and braking NOTE: Make sure each
wheel is installed on its proper hub as noted in removing (the "rotation arrow" must indicate forward direction of rotation)
NOTE: If pulling is noted, measure the circumference of the front and rear tires on the pulling sideCompare the measurements
with the tires on the opposite sideIf pulling is noted during braking only, check and adjust the brakes as necessary and
recheck operation (see Section 2) 5Increase the air pressure in the tires with the smallest circumference measurement until
all tires are equal in circumference6Repeat steps 4-5 as necessary to ensure proper handling 2Tighten to 5.5 kg-m (40 ft-lb)CHECKINGINFLATING