2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 481Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 481

Handlebar Grip REMOVING 1Remove the plug from the head of the rivet 2Using lI8-indrill bit, drill out the rivet3Using compressed
1Apply liberal amount of Handlebar Grip Adhesive (pn 0636-071) to the inside of the grip2Align the rivet hole in the grip
with the rivet hole in the handlebar; then align the notch (inside the grip) with the slot in the handlbar and slide the
grip onto the handlebar until it is fully seated3Wipe off any excess glue; then secure the grip with new rivet4Install the
plug on the head of the rivet 9Place the gas tank into positionSecure with screws and washers Steering Knuckles REMOVING
AND DISASSEMBLING 1Secure the ATV on support stand to elevate the wheel; then remove the wheel 10Connect the fuel hose to
the carburetor11Install the left-side panel (see Front FenderSide Panels in this section); then install the seat (see Seat
in this section) NOTE: Turn the gas tank valve to the ON position only if starting the engineMake sure the ATV is solidly