2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 485Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 485

10Place the washer onto the shaft; then secure the hub assembly with the nutTighten only until snug 16Remove the ATV from
to 2.8 kg-m (20 ft-lb) 12Secure the hub nut (from step 10) to the shaftTighten to 10.4 kg-m (75 ft-lb)13Install new cotter
pin and spread the pin to secure the nut14Install the wheel cap15Install the wheel and tighten to 5.5 kg-m (40 ft-lb) 3Place
the ATV in level position taking care not to push down or lift up on the front end; then tum the handlebar to the straight
ahead position NOTE: When measuring and adjusting, there should be normal operating load on the ATV (without an operator