2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 495Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 495

8Disconnect the wires from the accessory plug (if equipped); then remove the accessory plug from the fender9Remove the fenders
securing the fenders to the frame and footrests and finger-tighten; then tighten the ten fasteners securely4Connect the drive
selector linkage using existing hardwareTighten securely Fender Flaresl Extensions REMOVING 1Using side-cutter, remove the
appropriate plastic rivets NOTE: To remove front extension, first remove the grille; then remove the push nuts securing the
extension to the bumper 2Remove the cap screws securing the extensions or flares to the frame and footrest3Remove the self-tapping
screws securing the extension to the fenderINSTALLING 1Place the flare or extension into positionUsing the Plastic Rivet
Setter (pin 0444-056), secure with Plastic Rivets (pin 0423-046) or suitable 5Install the gear shift linkage cover in the