2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 496Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 496

Footrests REMOVING Belly Panel REMOVING 1Remove the cap screws secunng the fender extension to the footrestAccount for all
solvent2Inspect the footrest weldments for cracks or unusual bends3Inspect all tubing for cracks or unusual bendsINSTALLING
1Remove the cap screws securing the muffler to the frame and account for all mounting hardware2Loosen the damp at the mufflerexhaust
pIpe juncture; then remove the muffler 1Connect the foot brake cable to the brake pedal (right-side footrest)2Place the footrest
into position on the frame and loosely secure with the four cap screws3Secure the fender extension to the footrest with existing
hardwareTighten securely4Tighten the 10 mm footrest cap screws (from step 2) to 5.5 kg-m (40 ft-Ib); then tighten the mm
cap screws (from step 2) to 2.8 kg-m (20 ft-Ib)5Connect the foot brake switch to the main wiring harnessEnsure that the harness
is properly secured to the frame and away from any moving partsCH056D INSPECTING MUFFLER NOTE: Whenever part is worn excessively,