2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 498Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 498

CSecure the fuse panel to the fender with the two CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked,
the two cap screws (A and B)Tighten cap screw (A) to 2.5 kg-m (18 ft-lb) and cap screw (B) to 2.8 kg-m (20 ft-lb) Side Box
(TBX Model) REMOVING 1Pull the cargo box release lever (located on the left side between the cargo box and the rear tire)
and fully raise the cargo box2Pull the seat lock lever forward (located below the right side of the seat), raise the front
end of the seat, and slide it forward and off the ATV3Remove the two cap screws (located inside the side box) securing the
side box to the footrest4Remove the screw securing the side box to the side panel5Remove the two cap screws (A and B) securing
the side box to the frame NOTE: Cap screw (A) is in the position shown and is accessed from under the frame 2Secure the side
box to the side panel with the existing screw3Secure the side box to the footrest with existing hardwareTighten securely4Install