2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 499Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 499

3Remove the two cap screws and lock nuts securing the cargo box to the frame; then remove the cargo box and discard the lock
average operating load on the ATV when adjusting the headlight aim 2Measure the distance from the floor to the mid-point
of each headlight3Using the measurements obtained in step 2, make horizontal marks on the aiming surface4Make vertical marks
which intersect the horizontal marks on the aiming surface directly in front of the headlights5Switch on the lightsMake sure
the HIGH beam is onDO NOT USE LOW BEAM6Observe each headlight beam aimProper aim is when the most intense beam is centered
on the vertical mark cm (2 in below the horizontal mark on the aiming surface 1Clean all cargo box components with soap and
water2Inspect the cargo box for cracks, tears, and loose mounting hardware3Inspect the welds of the cargo box frame for cracking
or bending4Inspect the cargo box gate latches for smooth operationINSTALLING 1Place the cargo box into position on the frameSecure