2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 510Get this manual

2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 510

NOTE: Never reuse lock nutOnce lock nut has been removed, it must be replaced with new lock nut INSTALLING 1Place the shift
on the axle7Using two open-end wrenches, remove the lock nut (B) securing the shift rod to the upper shift armRemove the
shift rod and discard the lock nutAF941A 3Place the spring into position between the upper shift arm and shift lever; then
making sure the O-rings are in place on the axle, secure the shift lever to the arm with the existing axle and nut4Install
the gear shift linkage cover on the fender in the left-front wheel wellTighten the three machine screws securely5Place the
left-side panel into position on the frame and secure with the three machine screws6Install the gas tank (see Section 4);