2004 650 Twin Arctic Cat ATV Service Manual, Page 18Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 18

7Start the engine (while the ATV is outside on level ground) and allow it to idle for few minutes8Turn the engine off and
the filter 5Apply oil to new filter gasket and check to make sure it is positioned correctly; then install the new oil filterTighten
securelyNOTE: Install new filter gasket each time the filter is replaced ATV0100A 12Inspect the area around the drain plug
and oil filter for leaks 6Install the engine drain plug and tighten to 2.0 kg-m (14.5 ft-lb)Pour 2.05 (2.17 U.Sqt) of the
recommended oil in the filler holeInstall the oil level stickfiller plug Front DifferentialRear Drive Lubricant Check and
change the lubricant according to the Periodic Maintenance ChartWhen changing the lubricant, use approved SAE 80W-90 hypoid
gear lubeTo check lubricant, use the following procedure1Remove each filler plug; the lubricant level should be inbelow the
threads of the plugIf low, add SAE approved 80W-90 hypoid gear lube as necessary ! CAUTION Any oil used in place of the recommended