2004 650 Twin Arctic Cat ATV Service Manual, Page 27Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 27

REMOVING 1Make sure that the ignition switch is in the off position; then remove the clamps (A) and air duct (B) 4Remove
(A) (or mark the belt using tape or marker) in order to reinstall in the same direction as previously installed 6Lift the
belt (B) off the driven pulley (C) 3Remove the three cover bolts (B) in the positions shown and install an appropriate drive
clutch holder (A) as shownNote the holder's relative position to the arrow mark (D) NOTE: Inspection of the belt is required
every 100 hours or 1100 milesMore frequent inspection is required if the ATV is operated in adverse conditionsINSPECTING
1Measure the belt width (A) at several locations using pair of suitable straightedges (B) ! CAUTION Be sure to install the