2004 650 Twin Arctic Cat ATV Service Manual, Page 28Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 28

2If belt width is below the service limit of 28.8 mm (1.13 in or there is damage to the belt, it must be replacedINSTALLING
Detection Switch has been tripped to the OFF position, the V-belt cover and switch assembly must be replaced and the V-Belt
Failure Mode Clearing procedure (see Section 5) must be performed 4Install the cover seal into the V-belt cover with the
glue joint (A) as shown; then install the V-belt cover and tighten the cap screws to specifications 2Place straightedge (B)
on top of the belt between the drive clutch (C) and the driven pulley (D); then using ruler, check the belt deflection (A)Use
maximum force of kg (13 lb) on the rulerStandard belt deflection is 22-27 mm (0.87-1.06 inIf belt deflection is out of specifications,