2004 650 Twin Arctic Cat ATV Service Manual, Page 31Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 31

Table of Contents Removing EngineTransmission 3-3 Left-Side Components 3-6 Removing Left-Side Components 3-6 Right-Side Components
of components, it is advisable to remove front and rear racks, fenders, and side panels prior to engine removalKX130 5Drain
the coolant from the cooling system; then drain the oil from the enginetransmission AT THIS POINT If the technician's objective
is to servicereplace recoil starter, alternatorrotor flywheel, stator, pick-up coil, starter torque limiter, primary cam
chain, water pump impellerseal, starter clutch, and starter clutch gear, the enginetransmission does not have to be removed
from the frame Secure the ATV on support stand to elevate the wheels ! WARNING Make sure the ATV is solidly supported on
the support stand to avoid injury 6Remove the hardware securing the right-side and left-side panels; then remove the panels7Remove
the storage compartment cover housing, air filter, and air filter housing; then remove the V-belt cooling snorkel 1Remove
the seat; then turn the gas tank valve to the OFF position2Remove the negative cable from the battery; then remove the positive