2004 650 Twin Arctic Cat ATV Service Manual, Page 34Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 34

20Remove the rear engine mount through-bolt; then remove the rear engine mount brackets from the frameNOTE: Removing the
the four cap screws securing the recoil starter assembly to the left-side cover; then remove the recoil starterAccount for
the gasket2Drain the cooling system including the coolant reserve tank; then remove the coolant hoses (A), four cap screws
(B), and the water pump cover (C)Account for the gasket 22Raise the rear of the engine and maneuver forward to release the
rear drive coupler; then lower the rear and shift the engine to the rear to release the front drive couplerNOTE: This will
require an assistant to hold cables and lines clear and to assist in maneuvering the enginetransmission assembly out of the
frame 23Remove the enginetransmission assembly from the left side of the frameNOTE: Tape over or cap all open hoses, lines,
and vents to prevent contaminationMake sure that the gas tank valve is in the OFF position and the tank cap is securely tightened