2004 650 Twin Arctic Cat ATV Service Manual, Page 35Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 35

3Remove the V-belt cover (See Removing Right-Side Components); then remove the three clutch cover bolts (B) noting the arrow
remove the rotorflywheelAccount for the keyKX237 ! CAUTION If the rotor is difficult to remove, turn the screw while tapping
on the end of the puller screwDo not strike the rotorflywheel as sharp blow can cause magnets to lose strength 5Install two
mm cap screws (B) into the collar (A) and remove the collar; then place an oil pan under the left side of the engine 9Remove
the starter torque limiter (A) 6Disconnect the alternator and pick-up coil lead connectors; then remove the alternator cover