2004 650 Twin Arctic Cat ATV Service Manual, Page 61Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 61

3Loosen the bevel gear (B) using an Allen wrench while holding the housing (A) in vise; then continue to turn the bevel gear
can be removed from the housing; then remove the four holding bolts6Remove the bearing holder (A) using special hex wrench
(B)Apply heat to soften the Loctite 1Secure the driven bevel gear assembly holding tool (C) in vise; then set the housing
assembly (A) on the holder, tighten nuts (D), and compress the damping spring (E) KX304A KX301 7Remove the outer ball bearing
(A) using suitable seal and bearing remover (B); then remove the bevel gear retainer nut and the inner ball bearing 2Remove
the circlip (A); then loosen and remove the holder nuts and spring compressor3Remove the spring holder (B), spring (C), cam