2004 650 Twin Arctic Cat ATV Service Manual, Page 62Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 62

ATV2080 4Hold the housing assembly (A) with the output shaft holder (B) and spacer (C) in vise; then remove the oil seal
engine damageKX307 6With the housing assembly (A) secured on the holder (B), apply heat to the bearing retainer (C); then
use the special hex wrench (D) to remove the bearing retainerRemove the ball bearing from the housing 1Using press, install
ball bearings (A) and (B) into the crankcase making sure that the seal on bearing (B) is directed toward the crankcase; then
press in needle bearings (C) and (D) until flush with bore (insert bearing (D) from the outside)2Install the oil pressure