2004 650 Twin Arctic Cat ATV Service Manual, Page 66Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 66

Joining Crankcase Halves ABreather Tube BPositioning Bolt CDrive Bevel Gear (Assembling) DDriven Bevel Gear (Assembling)
the open end toward the left side (D) of the crankcase ATV2086 4Apply grease to the steel ball (A) and spring (B); then install
the steel ball, spring, washer (C), and shift shaft positioning bolt (D)Tighten the shift shaft positioning bolt to 2.5 kg-m
(18 ft-lb)ATV2083 2Apply blue Loctite #242 to the thread area (C), except tip (D) of left case cap screw (3); then install
and tighten the mm cap screws to 2.0 kg-m (14.5 ft-lb) following the tightening sequence 1-8Tighten the mm crankcase cap
screws (A) and (B) to 1.0 kg-m (7 ft-lb) ATV2087 5Check that the crankshaft and driven shaft turn freelyIf any of the shafts