2004 650 Twin Arctic Cat ATV Service Manual, Page 68Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 68

14Apply grease to the output drive oil seal; then install in the housing being careful not to damage the lip of the seal
screws (A) to 2.7 kg-m (19.5 ft-lb) 18Install the drive bevel gear housing (B); then tighten the four cap screws (A) to 2.7
kg-m (19.5 ft-lb) 16Install the guide bars (A), spring compressor (B), and nuts (C); then tighten the nuts (C) until the
circlip (D) can be installedAfter seating the circlip, remove the nuts (C), compressor (B), and guide rods (A)Apply grease