2004 650 Twin Arctic Cat ATV Service Manual, Page 76Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 76

3Apply clean engine oil to the piston skirts and cylinder walls; then install the cylinders and clamp (A) (rear only) and
then place new head gasket (B) into position and install the oil pipe (C) and camshaft chain guides (D) ATV2099 NOTE: When
installing the circlips in the piston, compress them only enough to installDo not over compress 5Install the cylinder heads
and tighten cap screws (A) in the sequence illustrated to 2.5 kg-m (18 ft-lb); then in the same sequence, tighten to the
final value of 5.0 kg-m (36 ft-lb)Tighten cap screw (B) to 1.0 kg-m (87 inlb) 2Install two alignment pins (A) for each cylinder;
then position new base gasket (B) as shown ATV2100 6Using wrench on the alternator bolt, turn the crankshaft clockwise to