2004 650 Twin Arctic Cat ATV Service Manual, Page 98Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 98

3Turn the ignition switch to the ON positionThe fuel pressure should build until the pump shuts offPressure should read
check the CDI and the vehicle tilt sensorNOTE: To test the fuel gauge tank sensor, the fuel pump assembly must be removedREMOVING
4Rotate the fuel pump assembly clockwise 90 to allow removal without removing the fuel tankKX188 5Lift out the fuel pump
assembly carefully tilting it forward to clear the voltage regulator; then guide the pump and float lever through the opening
in the gas tank 1Remove the rear rack and fenders; then disconnect the power supply fuel gauge connector ! CAUTION Take care
not to damage the float or float arm or replacement of the entire assembly will be necessary 2Remove the spring clamp; then