2004 650 Twin Arctic Cat ATV Service Manual, Page 99Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 99

INSPECTING AT THIS POINT If the pump has failed earlier test and must be replaced, proceed to INSTALLING NOTE: If readings
float or float lever 3Test the fuel gauge tank sensor by connecting multimeter (A) to the fuel sensor leads (B); then select
OHMSThe multimeter should show 120 ohms at full fuel position (C) and ohms at empty fuel position (D) 3Rotate the fuel pump
counterclockwise 90 or until the match marks align; then install the mounting screws and tighten securely using crisscross
patternNOTE: It is important to install the fuel pump with the correct orientation to ensure adequate float lever clearance
4Connect the wires, fuel hose, and spring clamp; then turn the ignition switch to the ON positionNote that the fuel pump
runs momentarily and the fuel gauge indicates the proper fuel level5With the transmission in neutral and brake lever lock