2004 650 Twin Arctic Cat ATV Service Manual, Page 102Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 102

Accessory ReceptacleConnector NOTE: This test procedure is for either the receptacle or the connectorVOLTAGE 1Set the meter
fuse, receptacle, connector, or the main wiring harness Always disconnect the battery when performing resistance tests to
avoid damaging the multimeter 1Set the meter selector to the OHMS position2Connect the red tester lead to one black wire;
then connect the black tester lead to the other black wire Brakelight Switch (Auxiliary) The switch connector is the two-prong
connector on the right side of the engine directly above the brake cable adjusterNOTE: The ignition switch must be in the
ON positionVOLTAGE (Wiring Harness Side) 1Set the meter selector to the D.CVoltage position2Connect the red tester to the
orange wire; then connect the black tester lead to ground 3When the brake pedal is depressed, the meter must show less than