2004 650 Twin Arctic Cat ATV Service Manual, Page 103Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 103

Brakelight Switch (Handlebar Control) The switch connector is the two-prong black connector in front of the steering postTo
the battery, fuse, switch, or the main wiring harnessNOTE: If the meter shows battery voltage, the main wiring harness is
good; proceed to test the switchcomponent, the connector, and the switch wiring harness for resistanceRESISTANCE (Switch
Connector) 2Suspend the switch and thermometer in container of water; then heat the waterNOTE: Neither the switch nor the
thermometer should be allowed to touch the bottom of the container or inaccurate readings will occurUse wire holders to suspend
switch and thermometer ! CAUTION Always disconnect the battery when performing resistance tests to avoid damaging the multimeterNOTE:
The brake lever must be compressed for this testAlso, the ignition switch must be in the OFF position 733-554E 1Set the meter
selector to the OHMS position2Connect the red tester lead to one black wire; then connect the black tester lead to the other