2004 650 Twin Arctic Cat ATV Service Manual, Page 105Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 105

1Set the meter selector to the OHMS position2Connect the red tester lead to one spade end of the fuse; then connect the black
only one side of the fuse holder connector terminal; the other side will show voltsNOTE: When testing the HI-Beam fuse holder,
the headlight dimmer switch must be in the HI position; when testing the LIGHTS fuse holder, the headlight dimmer switch
must be in the LO positionNOTE: If the meter shows no battery voltage, troubleshoot the battery, switches, or the power distribution
modulemain wiring harness ! WARNING Most voltages generated by the ignition system are sufficient to interrupt pacemakers!
All technicians, especially those using pacemakers, must avoid contact with all electrical connections when making these
testsPEAK VOLTAGE (Primary Side) NOTE: The ignition switch must be in the ON position; the emergency stop switch must be
in the RUN positionAlso, the front coil wire must be disconnected from the rear coil 1Set the meter selector to the D.CVoltage