2004 650 Twin Arctic Cat ATV Service Manual, Page 106Get this manual

2004 650 Twin Arctic Cat ATV Service Manual, Page 106

RESISTANCE ! CAUTION Always disconnect the battery when performing resistance tests to avoid damaging the multimeterNOTE:
the meter selector to the D.CVoltage position2Connect the red meter lead to the red wire; then connect the black meter lead
to ground3Meter must show battery voltageNOTE: If the meter shows no battery voltage, troubleshoot the battery or the main
wiring harnessRESISTANCE ! CAUTION Always disconnect the battery when performing resistance tests to avoid damaging the multimeterNOTE:
Perform this test on the upper side of the connector 2The meter reading must be within specificationNOTE: If the meter does
not show as specified, replace ignition coilSpark Plug Cap 1Turn the ignition switch to the ON position2Set the meter selector
to the OHMS position3Connect the red tester lead to the red wire; then connect the black tester lead to the brown wire4The